Panasonic KX-T336 System Reference Manual page 366

10.00 Operator Call
Description
Allow extension users to call the operator by
dialing the feature number for "Operator Call
cGen&al)" or "Operator
Call (Specific)."
Operation
1.
Up to two operators are assignable for the whole
system. If Tenant Service is available, two
operators are assignable for each tenant, that
makes four operators available for the whole
system.
If two operators are assigned in the system, or in
the
tenant (if tenant Service is employed),
extension users can specify the operator (in the
same tenant) by dialing the feature number for
"Operator Call (Specific)."
Programming
System Programming
Reference
r
VT 1 Dumb
I
' System-Numbering Plan (2/g)' , 94-6.02
1O-G10.00
Operator Call (Specific)
Operator Call (General)
Conditions
When calling an operator by dialing the feature
number for "Operator Call (General)," the
operator is selected according to the type of the
operators' stations as shown below:
Type of Station
Operator
1 Operator 2
-TzF-
ATT
ATT
ATT
EXT
Al-T
-
EXT -
- bperator
8elected
s: T"
-1 onfy
operalorf only
operator1 on&
Operator 1 only
2.
I22
4' .
L!fl
7.2
*
(Supplement)
Lift the handset or press the SP-
PHONE
button.
Calling an operator without
specifying
1)
Dial
the feature number for
"Operator Call (General)."
Calling an operator by specifying
1) Dial the feature number for
Qperator
Call (Specific)."
2) Dial ' 1 I to specify operator 1.
Dial ' 2' to specify operator 2.
.
If your PITS has a display, the following
message appears on the display:
:::-
When the called operator is at an Attendant
Console:
1 AlTConsole 1
.,I
When the called operator is at an extension:
&ample>
1 1000:Mary J
T-z
extension name
directory number
When no operators are assigned, a user hears
reorder tone during executing Operator Call.
For the assignment of operators, refer to Section
3-B-5.00 "Operator."
4-C-28