Table of Contents
Advertisement
LUNA2000-200KTL-H1 Smart Power Control System
User Manual
●
Using Ladders
●
●
●
●
●
●
●
●
Issue 08 (2024-01-23)
Before moving the equipment, secure it to the pallet truck or forklift using
ropes. When moving the equipment, assign dedicated personnel to take care
of it.
Choose sea, roads in good conditions, or airplanes for transportation. Do not
transport the equipment by railway. Avoid tilt or jolt during transportation.
Use wooden or insulated ladders when you need to perform live-line working
at heights.
Platform ladders with protective rails are preferred. Single ladders are not
recommended.
Before using a ladder, check that it is intact and confirm its load bearing
capacity. Do not overload it.
Ensure that the ladder is securely positioned and held firm.
When climbing up the ladder, keep your body stable and your center of
gravity between the side rails, and do not overreach to the sides.
When a step ladder is used, ensure that the pull ropes are secured.
If a single ladder is used, the recommended angle for the ladder against the
floor is 75 degrees, as shown in the following figure. A square can be used to
measure the angle.
If a single ladder is used, ensure that the wider end of the ladder is at the
bottom, and take protective measures to prevent the ladder from sliding.
Copyright © Huawei Technologies Co., Ltd.
1 Safety Information
10
Advertisement
Table of Contents
