Table of Contents
Advertisement
LUNA2000-200KTL-H1 Smart Power Control System
User Manual
Step 8 Delete the faulty Smart PCS.
Choose Maintenance > Connect Device, select the faulty Smart PCS, click
Remove Devices, and click Confirm.
Figure 8-25 Deleting a device
Step 9 Choose Maintenance > Connect Device, select the Smart PCS, and click
send a startup command. After the Smart PCS is started, check that it is running
properly.
Step 10 (Optional) Log in to the PV plant management system, access the plant, choose
Device Management, select the faulty Smart PCS, click Delete, and click OK.
Issue 08 (2024-01-23)
NO TE
– During the process of Search for Device, do not perform upgrade operations (such
as upgrading through the app, management system, or WebUI).
– When you click Search for Device, cable connections (DC and AC) will be checked
before device search (not applicable to third-party devices), and device addresses
will be automatically allocated.
– After the cable connection check and device search are complete, if a cable
connection alarm is generated, you can click the alarm icon
corresponding alarm information.
– If an alarm is generated when the cable connection check fails, click the alarm icon
to view the alarm cause and handling suggestions. After the fault is rectified,
check the cable connections again.
– After the cable connection check and device search are complete, click
the corresponding topology information.
– After a device is added or deleted, you need to click Search for Device again in
Deployment Wizard. Otherwise, the system topology will not be updated.
NO TE
● Perform this step if you purchase and use the PV plant management system.
● The software version corresponding to the user interface (UI) screenshot in this step is
iMaster NetEco V600R023C00SPC110. The UI may vary by software versions and the
screenshot is for reference only.
Copyright © Huawei Technologies Co., Ltd.
8 Device Maintenance
to view the
to view
to
82
Advertisement
Table of Contents
