Storage Requirements - Huawei LUNA2000-200KTL-H1 User Manual

LUNA2000-200KTL-H1 Smart Power Control System
User Manual
● Store Smart PCSs according to the storage requirements. Device damage
● Do not store Smart PCSs without outer packaging.
● Do not tilt a packing case or place it upside down.
If Smart PCSs will not be put into use immediately, store them according to the
requirements specified in this section. Device damage caused by unqualified
storage conditions is not covered under the warranty. Store Smart PCSs with outer
packaging in a ventilated, dry, and clean indoor environment. In addition, ensure
that the following requirements are met:
●
●
●
●
●
●
Issue 08 (2024-01-23)
NO TICE
caused by unqualified storage conditions is not covered under the warranty.
If Smart PCSs are unpacked but will not be used immediately, put them back
to the original packaging with the desiccant, and seal with tape.
When temporarily storing Smart PCSs outdoors, do not stack them on a
pallet. Take rainproof measures such as using tarpaulins to protect Smart
PCSs from rain and water.
Smart PCSs must be stored in a clean and dry environment with appropriate
temperature and humidity. The air must not contain corrosive or flammable
gases. Maintain a storage temperature between –40°C to +70°C, and humidity
between 5%–95% RH.
A maximum of four Smart PCSs can be stacked. To avoid personal injury or
device damage, exercise caution when stacking Smart PCSs to prevent them
from falling over.
Do not remove the outer packaging. Check the packaging regularly
(recommended: once every three months). Replace any packaging that is
damaged during storage.
Do not store Smart PCSs for more than two years. If Smart PCSs have been
stored for two years or longer, they must be checked and tested by
professionals before being put into use.
Copyright © Huawei Technologies Co., Ltd.
3

Storage Requirements

3 Storage Requirements
26