Configuring Idrac6 Network Properties - Dell IDRAC6 User Manual

cfgNicGateway=10.35.10.1
This file will be updated as follows:
#
Object Group "cfgLanNetworking"
#
#
[cfgLanNetworking]
cfgNicIpAddress=10.35.9.143
# comment, the rest of this line is ignored
cfgNicGateway=10.35.9.1
The command racadm config -f myfile.cfg parses the file and identifies any
errors by line number. A correct file will update the proper entries.
Additionally, you can use the same getconfig command from the previous
example to confirm the update.
Use this file to download company-wide changes or to configure new systems
over the network.
NOTE:
"Anchor" is an internal term and should not be used in the file.

Configuring iDRAC6 Network Properties

To generate a list of available network properties, type the following:
racadm getconfig -g cfgLanNetworking
To use DHCP to obtain an IP address, use the following command to write
the object cfgNicUseDhcp and enable this feature:
racadm config -g cfgLanNetworking -o cfgNicUseDHCP 1
The commands provide the same configuration functionality as the iDRAC6
Configuration Utility at boot-up when you are prompted to type
<Ctrl><E>. For more information about configuring network properties
with the iDRAC6 Configuration Utility, see "Configuring Your System to Use
an iDRAC6" on page 34.
123
Advanced iDRAC6 Configuration