Enabling Or Disabling The Vflash Or Standard Sd Card; Initializing The Vflash Or Standard Sd Card; Getting The Last Status On The Vflash Or Standard Sd Card; Resetting The Vflash Or Standard Sd Card - Dell IDRAC6 User Manual

Enabling or Disabling the vFlash or Standard SD Card

Open a telnet/SSH/Serial console to the server, log in, and enter the following
commands:
• To enable vFlash or standard SD card:
racadm config -g cfgvFlashsd -o cfgvflashSDEnable
1
• To disable vFlash or standard SD card:
racadm config -g cfgvFlashsd -o cfgvflashSDEnable
0
NOTE:
The RACADM command functions only if a vFlash or standard SD card is
present. If a card is not present, the following message is displayed:
Card not present

Initializing the vFlash or Standard SD Card

Open a telnet/SSH/Serial console to the server, log in, and enter the following
command to initialize the card:
racadm vflashsd
All existing partitions are deleted and the card is reset.

Getting the Last Status on the vFlash or Standard SD Card

Open a telnet/SSH/Serial console to the server, log in, and enter the following
command to get the status of the last initialize command sent to the vFlash
or standard SD card:
racadm vFlashsd status
NOTE:
This command only shows the status of commands sent to the SD card. To
get the status of commands sent to individual partitions on the SD card use the
command:
racadm vflashpartition status

Resetting the vFlash or Standard SD Card

Open a telnet/SSH/Serial console to the server, log in, and enter:
racadm vflashsd initialize
Configuring vFlash SD Card and Managing vFlash Partitions
.
initialize
ERROR: SD
273