Output; Getraclog; Synopsis; Description - Dell Remote Access Controller 4 Firmware Version 1.30 User Manual

Output

The serveraction command returns without output if successful.

getraclog

NOTE:
Table A-29 describes the getraclog command.
Table A-29. getraclog
Command
getraclog -i
getraclog

Synopsis

racadm getraclog -i
racadm getraclog [-A] [-c count ] [ delay-seconds ]\[-s start-
record ] [-v] [-V] [-m]

Description

NOTE:
The getraclog -i command displays the number of entries in the DRAC 4 log.
The following options allow the getraclog command to read entries:
• -A — Provides API-formatted output (no header).
• -c — Provides the maximum count of entries to be returned.
• <blank> — Displays the entire log; racadm and serial only (default).
• -d — Provides the number of seconds to delay the recording of any new log entries.
• -s — Provides the associated number of the first displayed entry (default = 0 [list begins with
the first DRAC 4 log entry]).
-v — Provides verbose output.
•
-V — Provides Very verbose output.
•
• -m — Displays 24 rows at a time, and queries for more (such as the UNIX more command).
Output
One line of output is displayed for each DRAC 4 log entry.
170
racadm Subcommand Man Pages
To use this command, you must have Log In DRAC 4 permission.
Definition
Displays the number of entries in the DRAC 4 log.
Displays the DRAC 4 log entries.
The command name and the racadm subcommand names may be different. This is normal.