Troubleshooting Network Problems; Table 4-30. Drac 4 Network Error Codes - Dell Remote Access Controller 4 Firmware Version 1.30 User Manual

Troubleshooting Network Problems

The internal DRAC 4 Trace Log can be used by administrators to debug alerting or networking
from the DRAC 4. The Trace Log can be accessed from the DRAC 4 Web-based interface by
clicking the Diagnostics tab, and typing the gettracelog command. The Trace Log will appear
and tracks the following information:
• DHCP — Traces packets sent to and received from a DHCP server.
• IP — Traces IP packets sent and received.
NOTE:
In the DRAC 4 Trace Log, nonprintable ASCII characters are translated to printable ASCII
characters. If the character code is less than 0x20, or between 0x7f and 0xa0 (inclusive), the value 0x40 is
exclusive and the character before printing, after a "^" is added to the beginning. As a result, the ASCII
carriage return character, 0xd, is printed as "^M" in the Trace Log.
NOTE:
The DRAC 4 will not echo an ICMP (ping) with a packet size larger than 1500 bytes.
The Trace Log may also contain DRAC 4 firmware-specific error codes (relating to the internal
DRAC 4 firmware, not the managed system's operating system). Use Table 4-30 to help
diagnose network problems reported by the internal DRAC 4 operating system.

Table 4-30. DRAC 4 Network Error Codes

Error Code
0x5006
0x5009
0x500D
0x5011
0x5016
0x5017
0x5020
0x5023
0x5024
0x5025
0x5027
0x5028
0x5029
0x502A
0x502B
0x502D
0x502F
78
Managing and Recovering a Remote System
Description
ENXIO: No such address.
EBADS: The socket descriptor is invalid.
EACCESS: Permission denied.
EEXIST: Duplicate entry exists.
EINVALID: An argument is invalid.
ENFILE: An internal table has run out of space.
EPIPE: The connection is broken.
EWOULDBLOCK: The operation would block; socket is nonblocking.
EINPROGRESS: Socket is nonblocking; connection not completed immediately.
EALREADY: Socket is nonblocking; previous connection attempt not complete.
EDESTADDRREQ: The destination address is invalid.
EMSGSIZE: Message too long.
EPROTOTYPE: Wrong protocol type for socket.
ENOPROTOOPT: Protocol not available.
EPROTONO SUPPORT: Protocol not supported.
EOPNOTSUPP: Requested operation not valid for this type of socket.
EAFNOSUPPORT: Address family not supported.