Configuring The Drac 4 - Dell Remote Access Controller 4 Firmware Version 1.30 User Manual

4 Click Next and browse to the SSL certificate file.
5 Install the RAC SSL Certificate in each domain controller's Trusted Root Certification
Authority.
If you have installed your own certificate, ensure that the CA signing your certificate is in the
Trusted Root Certification Authority list. If the Authority is not in the list, you must install it
on all your Domain Controllers.
6 Click Next and select whether you would like Windows to automatically select the certificate
store based on the type of certificate, or browse to a store of your choice.
7 Click Finish and click OK.

Configuring the DRAC 4

1 Log in to the Web-based interface using the default user, root, and its password.
2 Click the Configuration tab and select the Active Directory.
3 Select the Enable Active Directory check box.
4 Type the DRAC 4 Name. This name must be the same as the common name of the
RAC object you created in your Domain Controller (see step 3 of "Creating a RAC Device
Object").
5 Type the Root Domain Name. The Root Domain Name is the fully qualified root domain
name for the forest.
6 Type the DRAC 4 Domain Name (for example, drac4.com). Do not use the NetBIOS
name. The DRAC 4 Domain Name is the fully qualified domain name of the sub-domain
where the RAC Device Object is located.
7 Click Apply to save the Active Directory settings.
8 Click Upload Active Directory CA Certificate to upload your domain forest Root CA
certificate into the DRAC 4. Your domain forest domain controllers' SSL certificates need to
have signed this root CA certificate. Have the root CA certificate available on your local
system (see "Exporting the Domain Controller Root CA Certificate"). Specify the full path
and filename of the root CA certificate and click Upload to upload the root CA certificate to
the DRAC 4 firmware. The DRAC 4 Web server automatically restarts after you click Upload.
You must log in again to complete the DRAC 4 Active Directory feature configuration.
9 Click the Configuration tab and select Network.
10 If DRAC 4 NIC DHCP is enabled, select Use DHCP to obtain DNS server address. If you
want to input a DNS server IP address manually, deselect Use DHCP to obtain DNS server
address and type your primary and alternate DNS Server IP addresses.
11 Click Apply.
This completes the DRAC 4 Active Directory feature configuration.
Using the DRAC 4 With Microsoft
®
99
Active Directory