Adding And Configuring Snmp Alerts; Alert Properties - Dell Remote Access Controller 4 Firmware Version 1.30 User Manual

Adding and Configuring SNMP Alerts

NOTE:
You must have Configure DRAC 4 permission to add or delete an SNMP alert; otherwise,
these options will not be available.
1 Click the Configuration tab and select Alerts.
2 Use the Add/Configure SNMP Alerts page to add, delete, configure, and test SNMP alerts.
NOTE:
The DRAC 4 supports three severity levels: Informational, Warning, and Severe. Some events
support only the informational severity level because they deliver only a message.
Adding an Alert
1 Locate an available Destination IP Address in the Destination IP Address column.
NOTE:
If all Destination IP Addresses are filled with existing IP addresses, you have configured all
of your existing alerts and must delete one to continue.
2 Click [Available] to open the Add/Configure SNMP Alerts page.
3 Use Table 4-7 to configure the following properties under General.
Table 4-7. Alert Properties
Property
Enable SNMP Alert
Community
IP Address
Apply Changes
Go Back To SNMP
Alerts Page
Configuring Alerts by Severity
1 Use the Severity Configuration section to select which events, according to their severity, will
cause an SNMP alert to be sent to the IP address you typed in Configuring Alert Properties.
2 Select the severity of the sensor for which you want an SNMP alert generated.
3 Use Table 4-8 to decide which events you want to cause an SNMP alert.
Description
Determines whether you want to enable the current SNMP alert.
Specifies or edits the community name to which the destination IP address belongs.
Specifies or edits the destination IP address to which the alert is sent.
Commits changes made to the current alert.
Returns you to the Configure SNMP Alerts page.
Managing and Recovering a Remote System
63