Panasonic WJ-SX550A Operating Instructions Manual page 115

11. Camera Status Display
1. Select the desired camera and monitor.
Refer to the Camera Selection and Monitor Selection
on page 98.
Camera 01
Monitor 16
2. Select the Pan Action (B1) Menu on the LCD by press-
ing the appropriate Cursor Keys.
B1
Pan Action
Auto Random Status
F1 F2
3. Press the Function (F4) Key repeatedly to display or
erase the camera status as shown below.
Site Status
Ele Zoom:
Shutter :
Sens Up :
Random :
Auto Pan:
Camera :
Wiper :
Def :
AUX1 :
AUX2 :
C01 M16
12. Auxiliary Control
The following function is available only when WV-RC100,
WV-RC150 or WV-RC170 Receivers are included in the
system.
1. Select the desired camera and monitor.
Refer to the Camera Selection and Monitor Selection
on page 98.
2. Press the Auxiliary (AUX 1 or 2) Switch repeatedly to
turn on or off the user's auxiliary switch in the Receiver
(WV-RC100, WV-RC150 or WV-RC170).
AUX
1
F3 F4
2
13. Alarm Control
13-1 Alarm Input Selection
The following function is used to change the alarm input
selection by the System Controller After making the Alarm
Mode Select setting in the Setup Menu.
The selected mode is automatically stored in the Setup
Menu after turning power off of the Matrix Switcher.
1. Select the Alarm in (A5) Menu on the LCD by press-
ing the appropriate Cursor Keys.
A5
Alarm in
Site
F1 F2
2. Press the Function (F1) Key repeatedly to select the
alarm input On or Off from the camera site.
Press the Function (F2) Key repeatedly to select the
alarm input On or Off from the Alarm Board.
13-2 Alarm Operation
When an alarm sensor unit is activated, the Alarm Indicator
(ALARM) blinks. The indicator keeps blinking until all
alarms are cleared by pressing the Alarm Acknowledge
and Reset (ACK RESET) Switch.
13-3 To Cancel Alarm (Single Monitor)
The alarmed monitor(s) must first be selected. Press the
Alarm Acknowledge and Reset (ACK RESET) Switch once
for alarm acknowledgement. The LED indicator on the
switch blinks rapidly.
Press the Alarm Acknowledge and Reset (ACK RESET)
Switch once again for alarm reset. The LED indicator light
turns off.
RESET
-111-
Board
: On
: Off
ALARM LED
ACK ACK
RESET
6