22. System Menu
As shown below, the system menu allows access to six items.
To select an item from the System Menu:
1. Select the desired item by moving the Joystick Controller.
2. Press the Set (SET) Key to execute the selection. The selected menu appears on the monitor.
3. Press the Escape (ESC) Key to return to the Set Up Menu.
23. Controller
5
This table is used to prevent specific WV-CU550A System controllers from ever controlling the outputs of specific monitors.
This feature prevents an operator from unintentionally gaining control over a monitor that may not be associated with their station.
1. Move the cursor to the 3 position by moving the Joystick Controller, then press the Set (SET) Key.
2. Move the cursor to the desired controller and monitor position by moving the Joystick Controller. Press the Increment (INC)
Switch or Decrement (DEC) Switch repeatedly to select OK or NG.
3. Repeat the above procedure until the table is completed.
4. After completing the table, press the Escape (ESC) Key to escape from the programming mode. The cursor returns to the 3
position.
S e t
U p
S y s t e m
C o n t r o l l e r
E X T
T i m i n g S e l e c t
C o m p e n s a t i o n / V D 2
R S - 4 8 5 S i t e C o m m u n i c a t i o n
C o m m u n i c a t i o n
S p e e d
C l o c k
F 1 : - -
F 2 : - -
S e t
U p
S y s t e m
C T R L R
C o n t r o l l e r
M o n i t o r
1
2
C T R L R
1
C T R L R
2
C T R L R
3
C T R L R
4
C T R L R
5
C T R L R
6
C T R L R
7
C T R L R
8
P C
F 1 : - -
F 2 : - -
F 3 : - -
F 4 : - -
3
4
5
6
7
8
9
1 0 1 1 1 2 1 3 1 4 1 5 1 6
F 3 : - -
F 4 : P o p
-86-
. . O K
. . N G
U p