Camera - Panasonic WJ-SX550A Operating Instructions Manual

1. Log-in
To operate the Matrix Switcher System 500, a registered
operator must first supply their Operator Number and
Password to the system controller.
The operator number and password are established by
using the Set Up Menu. See page 83 for more details on
operator number registration.
If an attempt is made to enter an operator number and
password that do not match with the registered operator
numbers and passwords, entry into this system is denied.
As shown in the examples below, there are 2 additional
attributes associated with an operator: operator level and
priority. These items are described in more detail on page
19.
Operator Name:
Operator Number:
Operator Level:
Password:
Priority:
Operator Name:
Operator Number:
Operator Level:
Password:
Priority:
Notes:
1. Initially, Operator Number: 1
Password:
are registered at the factory to allow access for first
time system programming.
2. An operator can be logged-in to this system from sev-
eral system controllers.
3. If the main power of the Matrix Switcher is turned off,
log-in procedures must be performed again.
4. If power to the system controller is turned off, the sys-
tem controller will record operating status when power
is resupplied.
2. Camera and Monitor Selection
After log-in, the desired camera and monitor combination
can be selected.
Basically, any combination of camera and monitor, which
are connected to this unit, can be selected as shown
below.
WV-RC150
Mike
01
01
07171
1
Robert
30
05
11524
General Procedures
30
1. Select the desired monitor. (monitor and controller are
linked.)
2. Select the desired camera (camera and controller are
linked.)
3. The picture of the selected camera is displayed on the
12345
selected monitor.
2-1 Monitor Selection
By selecting the monitor with the System Controller, it is
linked with the System Controller.
At this time, the camera output signal that was last sup-
plied to the monitor is displayed.
Press the Numeric keys (1 to 16) then press the MON key
to select the desired monitor.
For example: When selecting monitor No. 5:
-13-
Camera-1 Camera-2
Monitor-1
3
WJ-SX550A
2 1
Controller
1 2 3
4 5 6
7 8 9
0
MON CAM
ESC SET
Press 5 then press MON key.
2
Monitor-2