Panasonic WJ-SX550A Operating Instructions Manual page 15

FEATURES OF THE SYSTEM 500 MATRIX SWITCHER
Preface
The system shown below is an example of the expansion capabilities of the WJ-SX550A Matrix Switcher.
2
Printer
Computer
RS-232C Port
WV-CU550A System Controller (Max 8 Controller)
Camera Input: Up to 128 cameras can be connected. The pan/tilt head, zoom /focus/iris of the lens and AUX switching can be
controlled via a single coaxial cable through a receiver. Also preset control of the lens and pan/tilt head position is possible by
using the WV-CS500 or WV-CS600 Combination Camera System.
Monitor Output: Up to 16 monitors can be connected. The camera title, camera and monitor number and alarm condition can be
displayed on the monitor screen.
System Controller: Up to 8 controllers may be connected. A variety of controls are accessible through the LCD display on the
system controller. Also, access to the Programming Set Up Menu may be gained through the system controller.
VCR: Up to 16 VTRs can be connected. The video signal controlled by the WJ-SX550A Matrix Switcher is supplied to the VTR.
Also, the Matrix Switcher can supply the VTRs with an alarm output signal to switch time lapse recording mode.
Alarm Input: Up to 128 alarm signals can be supplied. An Alarm Sensor Unit with a Normally Open or Normally Closed circuit
should be used.
Printer Output: The Set Up Menu Programming data can be printed out.
RS-232C Port: A Personal Computer can be used instead of the WV-CU550A System Controller.
Note: When using a Personal Computer, the software must be purchased locally (not supplied with WJ-SX550A Matrix
Switcher).
WV-PB5504AE
CPU Control
4ch
Board Board
Output Board
X4
WJ-SX550A
Matrix Switcher
Video Monitor (Max. 16 Output)
64 cameras
WV-PB5508E WV-PB5564E
Ext. Ext.
8ch Alarm
Board Board
Input Board Board
X8 X2
Max 16 VTR Control Outputs
TL TL
TL TL
-12-
128 cameras
128 Alarm Input
WV-PB5504AE WV-PB5508E
4ch 8ch
Output Board Input Board
X4 X8
WJ-AD550
Extension Unit
TL TL
TL TL