Panasonic WJ-SX550A Operating Instructions Manual page 116

Note: "AL0" or "AL1" is displayed on the upper right
corner of the alarmed monitor.
07,MAY'96 14:23:56
C 01 M16 3rd Floor
13-4 To Cancel Alarm (Plural Monitors)
The following function is used to cancel alarm in a lump
when activating the Alarm Mode 1 or 2.
1. Select the alarmed monitor.
Select monitor 1 on activating the Alarm Mode 1 or
select one of monitors 1 - 4 on activating the Alarm
Mode 2.
2. Press the Alternate (ALT) Switch to light up the LED
indicator on the switch.
3. Press the Alarm Acknowledge and Reset (ACK
RESET) Switch once for alarm acknowledgement. The
LED indicator on the switch blinks rapidly.
4. Press the Alarm Acknowledge and Reset (ACK
RESET) Switch once again for alarm reset. The LED
indicator light turns off.
6
ALT
Note: Select one of the monitors, that is activated the
Group Sequence by motivating the Alarm Mode
3, then follow the steps above to cancel the
alarmed monitors at once.
ALO
Room 306
ACK ACK
RESET RESET
14. Preset Setting (WV-CS500 Only)
The following function is only available with the cameras
that have preset panning functions, such as the Panasonic
WV-CS500.
14-1 Preset Menu Setting
1. Select the desired camera and monitor.
Refer to the Camera Selection and Monitor Selection
on page 98.
2. Select the Preset (D3) Menu on the LCD by pressing
the appropriate Cursor Keys.
D3
Preset Menu:CS500
On
F1 F2
3. Press the Function (F1) Key to select the Preset
Program Mode.
The Preset Program Menu appears on the selected
monitor.
Refer to the Preset Program Menu shown on next
page.
Preset Menu:CS500
On
F1 F2
Preset/BLC Clear
Pre
F1 F2
Press the Function (F2) Key to select the Refresh
Mode.
The selected camera has it's PAN/TILT/ZOOM/
FOCUS functions automatically activated.
Note: Use the refresh mode if the preset positions
become slightly different from the initially set posi-
tions.
-112-
Refresh
F3 F4
Refresh
F3 F4
BLC
F3 F4