Panasonic WJ-SX550A Operating Instructions Manual page 48

WV-PB5548E Data Board Dip Switch Setting
1. Set switches (SW1) on the board to meet the data
board number as shown in the following table.
Initially, board number 1 is selected at the factory.
SW100
SW150
SW200
3
SW250
SW300
SW350
SW400
SW450
2. Set switches (SW100/SW150/SW200/SW250/SW300/
SW350/SW400/SW450) on the board to choose the
communication lines as either Full Duplex (FULL) or
Half Duplex (HALF).
Initially, Full Duplex(FULL) positions are selected at
the factory.
3. Set switch (SW5) on the board to choose the LED indi-
cator as either "ON" or "OFF" mode. The indicator dis-
plays that the control data are activated normally on
the board.
Initially, "ON" position is selected at the factory.
4. Confirm switches (SW3/SW6) on the board are set to
the following positions.
These switches are used only for factory test.
Always keep these switches in these positions in the
field.
SW1
SW6
Note
BOARD
NO.
1
2
3
4
5
6
7
8
FULL
HALF
SW100 - SW450
LED
SW5
1
1 2 3 4
OFF
SW3
-44-
SW1 SETTING
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
1 2 3 4
OFF
Full: 4 Lines
Half: 2 Lines
ON
OFF
PROG 2
SW6