Panasonic WJ-SX550A Operating Instructions Manual page 99

OPERATING PROCEDURE
Before starting the following procedures, all system com-
ponents should be turned on.
1. Log-in
1. Turn on the power switches of all system components.
Caution: If the WJ-AD550 Extension Unit is used in
the system, turn the Extension Unit power on
before turning power on the WJ-SX550A Matrix
Switcher.
2. Press the Controller On/Off Switch located on the rear
of the System Controller, to the ON position.
Initial Check
9600 BPS
Log-in
3. Press the CAM (SET) Key, the Operator No. display
now appears on the LCD.
Log-in
1 2
4 5
7 8
0
MON
ESC
Operator No :
3
6
9
CAM
SET
-95-
4. Enter the registered Operator No. by pressing the
Numeric Keys, then press the CAM (SET) Key.
Initially, 1 is selected at the factory.
Operator No :
1 2
4 5
7 8
0
MON
ESC
Operator No : 1
See page 83 for details on registering operator num-
bers.
5. Enter the registered Password (five numbers) by
pressing the Numeric Keys.
Initially, 12345 are selected at the factory.
Password :
1 2
4 5
7 8
0
MON
ESC
Welcome
See page 83 for details on registering password num-
bers.
Note: If the Auto Log-in Setting is selected On mode,
any operator can be Log-in automatically as an
operator previously.
Refer to the Auto Log-in Setting on page 117.
3
6
9
CAM
SET
....
3
6
9
CAM
SET
6