Panasonic WJ-SX550A Operating Instructions Manual page 55

Installing Additional Boards for Expansion
• Extension Unit is not required.
Caution
Before installing any boards be sure to turn off the
Power Switch of the WJ-SX550A Matrix Switcher.
1. Remove the screws from the rear panel(s) of the
Matrix Switcher.
2. Remove the rear panel(s).
3. Place the Board into the desired position in the rear of
Matrix Switcher by sliding it inside the board guides.
Note
Each slot is identical, so the board can installed in any
slot.
However it is recommended to install the boards as
shown below for an orderly installation.
Alarm Board
CPU CONTROL ALARM INPUT INPUT INPUT
VIDEO OUT1 VIDEO OUT1 VIDEO OUT1
RS-232C
DATA 1
00
DATA 2
MODE
5 CAMERA IN CAMERA IN CAMERA IN
1 1 1
DATA 3
TEST
TIME
RESET 2 2 2
ADJUST IN
COM DATA 4
1-32
3 3 3
DATA 5
PRINTER
4 4 4
DATA 6
5 5 5
DATA 7
6 6 6
33-64
DATA 8
7 7 7
VS/VD
IN
8 8 8
TEST 1
OUT
TEST 2
VD
OUT
VIDEO OUT2 VIDEO OUT2 VIDEO OUT2
Video Input Board
4. Make sure to push in the Board until it is seat-
ed firmly.
5. Secure the Board by tightening the two screws
on the board.
6. Close off open spaces on the rear of the Matrix
Switcher by using WV-Q63E Blank Panels
(Optional) or supplied rear panel(s).
OUTPUT OUTPUT
INPUT INPUT INPUT INPUT INPUT
VIDEO OUT1 VIDEO OUT1 VIDEO OUT1 VIDEO OUT1 VIDEO OUT1
CAMERA IN CAMERA IN CAMERA IN CAMERA IN CAMERA IN
1 1 1 1 1
ALARM OUT ALARM OUT
RESET OUT RESET OUT
2 2 2 2 2
EXT TIMING IN EXT TIMING IN
RECOVER IN RECOVER IN
MONITOR MONITOR
3 3 3 3 3
IN IN
1 1
OUT OUT
4 4 4 4 4
5 5 5 5 5
IN IN
2 2
OUT OUT
6 6 6 6 6
7 7 7 7 7
IN IN
3 3
OUT OUT
8 8 8 8 8
IN IN
4 4
OUT OUT
VIDEO OUT2 VIDEO OUT2 VIDEO OUT2 VIDEO OUT2 VIDEO OUT2
Video Output
Board
-51-
OUTPUT OUTPUT
ALARM OUT ALARM OUT
RESET OUT RESET OUT
EXT TIMING IN EXT TIMING IN
+9V
RECOVER IN RECOVER IN
MONITOR MONITOR
+5V
5V
IN IN
1 1
OUT OUT
POWER
IN IN
2 2 ON
OUT OUT
OFF
IN IN
3 3
OUT OUT
IN IN
4 4 11A00001
OUT OUT
Rear Panel
Remove four
screws.
Tighten screws.
Blank Panel
or
Board Tighten screws.
4