Quick Setup - Panasonic KX-TDA100 Features Manual

2.3 System Data Control
Conditions
• Class of Service (COS) programming determines the level of programming an extension user is
authorized to perform (→ Programming Mode Limitation [516]):
– System programming and personal programming
– Personal programming only
– No programming may be performed
• The extension which is connected to the lowest numbered port on the card installed in the lowest
numbered slot can perform both personal programming and system programming regardless of the
extension's COS.
• COS programming determines which extensions are manager extensions and can therefore perform
manager programming.
• During programming, the PT is considered to be busy and will not receive calls.
• Only one system programming (including PC programming) or manager programming session is
permitted at a time, i.e., these two programming features cannot be performed simultaneously by two
users.
• The PBX will allow 16 simultaneous personal programming sessions, or one system or manager
programming session and 15 personal programming sessions.
• System Programming Password Level
To access system programming, a valid password must be entered. For more details, see Section 3.1
Introduction.
• Personal Programming Data Reset
A PT user can return settings made through personal programming (Preferred Line Assignment, Live
Call Screening Mode, etc.) to their default settings all at once.
Feature References
2.2.6 Manager Features
3.3 PT Programming
Operation References
3.1 Personal Programming
3.2 Manager Programming
3.3 System Programming
2.3.3

Quick Setup

Description
Basic PBX parameters can be programmed the first time the PBX is accessed with a PC using the KX-TDA
Maintenance Console software.
When the PBX is accessed with the Installer Level Programmer Code and default password (→ 3.1
Introduction), for the first time (i.e., accessed after the PBX's settings have been initialized or when the
PBX's settings are still set to their default values), Quick Setup will launch automatically. From here the
following basic parameters can be programmed as desired:
248 Feature Guide