Panasonic KX-TDA100 Features Manual page 92

1.9 Automatic Route Selection (ARS) Features
[Carrier Selection Procedure Flowchart]
The numbers in parentheses indicate the corresponding items found under [Programming Procedures] on
the following pages.
An extension user accesses a CO
line and dials a telephone number.
Is the ARS mode (1) enabled?
Is the dialed number found in the
Leading Number Exception Table (2)?
Is the dialed number found in
the Leading Number Table (3)?
Checks the Routing Plan (4) to
determine which carrier to use.
Is the carrier found in the
appropriate time block (4)?
Is there an available
CO line group (5)?
Modifies the dialed number by
removing the digits and following
the modify commands (5).
Sends the modified number
to the CO line.
[Programming Procedures]
1.
ARS Mode (→ ARS Mode [320])
ARS is turned on by selecting under which circumstances it operates – either when an extension user
makes a call using the Idle Line Access method, or when any CO Line Access method is used. (→
1.5.5.3 CO Line Access). ARS can also be turned off for the entire system.
2.
Leading Number Exception Table
Once ARS is activated, store the telephone numbers that will bypass ARS in the Leading Number
Exception Table.
Note that the first few digits (leading number) of a telephone number, such as an area code or local
exchange, can also be stored, so that all calls to those areas or exchanges are exempted from ARS.
Also note that the CO Line Access number is always ignored by ARS and does not need to be
programmed here.
92 Feature Guide
Yes
No
Yes
Yes
Yes
No (Normal CO Line Access)
Sends the telephone
number as dialed.
Yes
No
No
No
No
Because all CO
lines are busy?
Is normal
Yes
CO Line Access
allowed?
No
Sends a
Sends a
busy tone. reorder tone.
Yes
(default)
Sends the telephone
number by the Idle
Line Access.