Ip-Extension Port [1-15] - Panasonic KX-TDA100 Features Manual

4.7 Configuration [1]
Value Range
Not applicable.
Programming Guide References
4.7.28 IP-GW Port [1-10]
Feature Guide References
None
OUS
Takes the port out of service. This enables a temporary non-use of the port, for example, for the purpose of
repair.
Default
Not applicable.
Value Range
Not applicable.
Programming Guide References
4.7.28 IP-GW Port [1-10]
Feature Guide References
None

4.7.30 IP-Extension Port [1-15]

Various settings can be programmed for each IP extension port.
IP-PT Registration and De-registration
An IP-PT must be registered to the PBX by programming both the PBX and IP-PT before it can be used.
Programming instructions of the PBX are given below.
If desired, it is possible to de-register the IP-PT later.
Preparation
Follow the steps below to prepare before registering an IP-PT.
1.
Open 4.7.9 Slot [1-1] IP-Extension Card Property, and confirm that the IP address and subnet
mask settings of the IP-EXT16 card are correct.
2.
Open 4.8.28 IP Extension Settings [2-13], and set the gateway address.
Registration
Follow the steps below to register the IP-PT.
1.
Connect the IP-PT to be registered to the network and, if necessary, the power supply.
434 Feature Guide