Fip-1. 3 003-356 Restart Printer - Dell 2130cn Service Manual

FIP-1. 3 003-356 Restart Printer

If the error occurred after replacing the PWBA MCU, transfer the internal data of the old
PWBA MCU to a new one.
Step
Possible causative parts:
PHD ASSY (PL4.1.21)
TONER CARTRIDGE (K) (PL5.1.21)
TONER CARTRIDGE (C) (PL5.1.22)
TONER CARTRIDGE (M) (PL5.1.23)
TONER CARTRIDGE (Y) (PL5.1.24)
HARN ASSY TONER CRUM (PL5.1.26)
PWBA MCU (PL8.2.13)
PWBA EEPROM (XPRO) (PL8.2.16)
HARN ASSY PHD XPRO (PL9.1.11)
Does the error still occur after several ON/OFF procedures
1
of the power?
Checking after reseating the PHD ASSY and TONER
CARTRIDGEs
2 Reseat the PHD ASSY and four TONER CARTRIDGEs.
Does the error still occur when the power is turned OFF and
ON?
Checking after reseating the PWBA MCU
Reseat the PWBA MCU.
3
Does the error still occur when the power is turned OFF and
ON?
Checking the connectors for connection
Are the following connectors connected correctly?
- P/J311 on the Toner CRUM (Y)
- P/J312 on the Toner CRUM (M)
- P/J313 on the Toner CRUM (C)
- P/J314 on the Toner CRUM (K)
- P/J31 on the PWBA MCU
- P/J42 on the PWBA MCU
- P/J144 on the PWBA EEPROM (XPRO)
- P/J422 on the PHD ASSY
4
P/J314
P/J313
P/J312
P/J311
Does the error still occur when the power is turned OFF and
5
ON?
Check
1 - 171
Yes
Go to step 2.
Go to step 3.
Go to step 4.
P/J422
Go to step 6.
P/J144
P/J42
P/J31
Wsb01004KA
Go to step 6.
Chapter 1 Troubleshooting
Remedy
No
End of work. *1
End of work. *1
End of work. *1
Reconnect the
connector(s) P/J
311 to P/J314, P/
J31, P/J42, P/
J144 and/or P/
J422 correctly,
then go to step 5.
End of work.