Dell 2130cn Service Manual page 697

Chapter 3 Removal and Replacement Procedures (RRPs)
Replacement 49 KIT FUSER ASSY (PL6.1.97)
1) Insert the two studs of the FUSER
ASSY into the holes of the printer.
2) Engage the connector (P/J171) of the
FUSER ASSY by pushing the FUSER
ASSY.
3) Close the TRANSFER ASSY.
4) Close the COVER ASSY FRONT.
Note: When the FUSER ASSY is replaced with a new one, perform the following steps.
5) Plug in the power cord to the printer.
6) Initialize the Life Counter of the FUSER ASSY.
7) Turn off the power.
8) Turn on the power while pressing the " " key and" " key on the control panel.
9) Press the " " key several times until "Parameter" is displayed. Press the " " key once.
10) Press the " " key several times until "Life Fuser Sheet" is displayed. Press the " " key once.
11) Press the " " key several times until "Initializing" is displayed. Press the " " key once.
12) Press the " " key once, and Initializing the Life Counter of the FUSER ASSY is performed.
13) Turn off the power to exit.
3 - 246