Chapter 3 Removal and Replacement Procedures (RRPs)
2) Secure the BRACKET MCU L and the
left side of the printer frame with the two
screws (silver, tap, 8mm).
3) Secure the rear side DISPENSER
ASSY with the one screw (silver, M4,
6mm) and BRACKET MCU L with the one
screw (silver, tap, 8mm).
4) Route the HARNESS ASSY B and the
HARN ASSY OOPTION to the
DISPENSER ASSY. Secure the harnesses
using the hooks on the DISPENSER
ASSY.
3 - 150