Fip-1. 18 Ready To Print 010-421 - Dell 2130cn Service Manual

FIP-1. 18 Ready to Print 010-421

Step
Possible causative parts:
FUSER ASSY (PL6.1.1)
PWBA MCU (PL8.2.13)
Checking the FUSER ASSY for installation
Is the FUSER ASSY installed correctly?
1
Warning: Start the operation after the FUSER ASSY has
cooled down.
2 Does the error still occur when the power is turned ON?
Checking after replacing the FUSER ASSY
Replace the FUSER ASSY. (Refer to Removal 5/
Replacement 49.)
Warning: Start the operation after the FUSER ASSY has
3
cooled down.
Does the error still occur when the power is turned ON?
NOTE: After replacement, be sure to clear the life counter
value.
Check
1 - 198
Chapter 1 Troubleshooting
Remedy
Yes
Reseat the
Go to step 3. FUSER ASSY,
then go step 2.
Go to step 3. End of work.
Replace the
PWBA MCU.
(Refer to Removal End of work
43/ Replacement
11.)
No