Dell 2130cn Service Manual page 360

Step
Checking the PHD ASSY for connection
Remove the PHD ASSY.
Are five HV terminals on the PHD ASSY, and five springs on
the frame (PL4.1.10 and PL4.1.15 to 18) dirty and/or
deformed?
8
Checking after reseating the PHD ASSY
9 Reseat the PHD ASSY.
Is the image printed correctly?
Checking after reseating the FUSER ASSY
Reseat the FUSER ASSY.
10 Warning: Start the operation after the FUSER ASSY has
cooled down.
Is the image printed correctly?
Checking after reseating the PWBA MCU
11 Reseat the PWBA MCU.
Is the image printed correctly?
Checking after reseating the PWBA ESS
12 Reseat the PWBA ESS.
Is the image printed correctly?
Checking after reseating the TRANSFER ASSY
13 Reseat the TRANSFER ASSY.
Is the image printed correctly?
Checking after reseating the PWBA HVPS
14 Reseat the PWBA HVPS.
Is the image printed correctly?
Checking after replacing the TONER CARTRIDGEs
Replace the TONER CARTRIDGE(s). (Refer to Removal 6/
15
Replacement 48.)
Is the image printed correctly?
Checking after replacing the PHD ASSY
Replace the PHD ASSY. (Refer to Removal 4/Replacement
16
50.)
Is the image printed correctly?
Check
1 - 334
Chapter 1 Troubleshooting
Remedy
Yes
Clean and/or
replace the PHD
Go to step 9.
ASSY or
SPRING(s).
End of work. Go to step 10.
End of work. Go to step 11.
End of work. Go to step 12.
End of work. Go to step 13.
End of work. Go to step 14.
End of work. Go to step 15.
End of work. Go to step 16.
End of work. Go to step 17.
No