D-Link DES-1228 Reference Manual page 157

Command
show 802.1x user
Each command is listed, in detail, in the following sections
enable 802.1x
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable 802.1X switch wide:
DES-1228/ME:4#enable 802.1x
Command: enable 802.1x
Success.
DES-1228/ME:4#
disable 802.1x
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable 802.1x on the Switch:
DES-1228/ME:4#disable 802.1x
Command: disable 802.1x
Success.
DES-1228/ME:4#
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
Used to enable the 802.1X server on the Switch.
enable 802.1x
The enable 802.1x command enables the 802.1X Network Access control application on
the Switch. To select between port-based or Host-based, use the config 802.1x
auth_mode command.
None.
Only Administrator-level users can issue this command.
Used to disable the 802.1X server on the Switch.
disable 802.1x
The disable 802.1x command is used to disable the 802.1X Network Access control
application on the Switch.
None.
Only Administrator-level users can issue this command.
152