D-Link DES-1228 Reference Manual page 259

Example usage
To configure the delay-interval interval:
DES-1228/ME:4# config lldp tx_delay 8
Command: config lldp tx_delay 8
Success.
DES-1228/ME:4#
config lldp reinit_delay
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To change the re-initialization delay interval:
DES-1228/ME:4# config lldp reinit_delay 5
Command: config lldp reinit_delay 5
Success.
DES-1228/ME:4#
config lldp notification_interval
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To change the notification interval:
DES-1228/ME:4# config lldp notification_interval 10
Command: config lldp notification_interval 10
Success.
DES-1228/ME:4#
config lldp ports notification
Purpose
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Change the minimum time of reinitialization delay interval.
config lldp reinit_delay < sec 1 – 10 >
An re-enabled LLDP port will wait for reinit_delay after last disable command before
reinitializing
reinit_delay − The range is from 1 second to 10 seconds. The default setting 2 seconds.
Only Administrator-level users can issue this command.
Used to configure the timer of the notification interval used to send notifications to
configured SNMP trap receiver(s).
config lldp notification_interval <sec 5 - 3600 >
Globally change the interval between successive LLDP change notifications generated by
the switch.
notification_interval − The range is from 5 second to 3600 seconds. The default setting is 5
seconds.
Only Administrator-level users can issue this command.
Used to configure each port for sending notifications to configured SNMP trap receiver(s).
254