D-Link DES-1228 Reference Manual page 222

config authen server_group
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To add an authentication host to server group "group_1":
DES-1228/ME:4# config authen server_group group_1 add server_host 10.1.1.121 protocol
tacacs+
Command: config authen server_group group_1 add server_host 10.1.1.121 protocol tacacs+
Success.
DES-1228/ME:4#
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Used to configure a user-defined authentication server group.
config authen server_group [tacacs | xtacacs | tacacs+ | radius | <string 15>] [add |
delete] server_host <ipaddr> protocol [tacacs | xtacacs | tacacs+ | radius]
This command will configure an authentication server group. A server group is a technique
used to group TACACS/XTACACS/TACACS+/RADIUS server hosts into user defined
categories for authentication using method lists. The user may define the type of server
group by protocol or by previously defined server group. Up to eight authentication server
hosts may be added to any particular group
server_group − The user may define the group by protocol groups built into the Switch
(TACACS/XTACACS/TACACS+/RADIUS), or by a user-defined group previously created
using the create authen server_group command.

tacacs – Use this parameter to utilize the built-in TACACS server protocol on the
Switch. Only server hosts utilizing the TACACS protocol may be added to this
group.

xtacacs – Use this parameter to utilize the built-in XTACACS server protocol on
the Switch. Only server hosts utilizing the XTACACS protocol may be added to
this group.

tacacs+ – Use this parameter to utilize the built-in TACACS+ server protocol on
the Switch. Only server hosts utilizing the TACACS+ protocol may be added to
this group.

radius – Use this parameter to utilize the built-in RADIUS server protocol on the
Switch. Only server hosts utilizing the RADIUS protocol may be added to this
group.
<string 15> − Enter an alphanumeric string of up to 15 characters to define the

previously created server group. This group may add any combination of server
hosts to it, regardless of protocol.
add/delete – Enter the correct parameter to add or delete a server host from a server
group.
server_host <ipaddr> − Enter the IP address of the previously configured server host to
add or delete.
protocol – Enter the protocol utilized by the server host. There are three options:

tacacs – Use this parameter to define the protocol if the server host is using the
TACACS authentication protocol.

xtacacs – Use this parameter to define the protocol if the server host is using the
XTACACS authentication protocol.

tacacs+ – Use this parameter to define the protocol if the server host is using the
TACACS+ authentication protocol.

radius – Use this parameter to define the protocol if the server host is using the
RADIUS authentication protocol.
Only Administrator-level users can issue this command.
217