D-Link DES-1228 Reference Manual page 167

Timeout : 5 seconds
Retransmit : 2
Index IP Address
----- ------------------
1 10.1.1.1
2 20.1.1.1
3 30.1.1.1
Total Entries : 3
DES-1228/ME:4#
create 802.1x guest_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure a previously created VLAN as an 802.1X Guest VLAN for the Switch:
DES-1228/ME:4#create 802.1x guest_vlan Trinity
Command: create 802.1x guest_vlan Trinity
Success.
DES-1228/ME:4#
config 802.1x guest_vlan ports
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Auth-Port
Number
---------
1812
1800
1812
Used to configure a pre-existing VLAN as a 802.1X Guest VLAN.
create 802.1x guest_vlan <vlan_name 32>
The create 802.1x guest_vlan command is used to configure a pre-defined VLAN as a
802.1X Guest VLAN. Guest 802.1X VLAN clients are those who have not been authorized
for 802.1X or they haven't yet installed the necessary 802.1X software, yet would still like
to have limited access rights on the Switch.
<vlan_name 32> − Enter an alphanumeric string of no more than 32 characters to define a
pre-existing VLAN as a 802.1X Guest VLAN. This VLAN must have first been created with
the create vlan command mentioned earlier in this manual.
Only Administrator-level users can issue this command.
Users must have already previously created a VLAN using the create vlan command.
Only one VLAN can be set as the 802.1X Guest VLAN.
Used to configure ports for a pre-existing 802.1X guest VLAN.
config 802.1x guest_vlan ports [<portlist> | all] state [enable | disable]
The config 802.1x guest_vlan ports command is used to configure ports to be enabled
or disabled for the 802.1X guest VLAN.
<portlist> − Specify a port or range of ports to be configured for the 802.1X Guest VLAN.
all – Specify this parameter to configure all ports for the 802.1X Guest VLAN.
state [enable | disable] – Use these parameters to enable or disable port listed here as
enabled or disabled for the 802.1X Guest VLAN.
Only Administrator-level users can issue this command.
Users must have already previously created a VLAN using the create vlan command. If
Acct-Port Status
Number
--------- --------------
1813 Active
1813 Active
1813 Active
162
Key
---------------
switch
des3226
dlink