D-Link DES-1228 Reference Manual page 229

config ssh authmode
Parameters
Restrictions
Example usage:
To enable the SSH authentication mode by password:
DES-1228/ME:4#config ssh authmode password enable
Command: config ssh authmode password enable
Success.
DES-1228/ME:4#
show ssh authmode
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To view the current authentication mode set on the Switch:
DES-1228/ME:4#show ssh authmode
Command: show ssh authmode
The SSH authmode:
Password : Enabled
Publickey : Enabled
Hostbased : Enabled
DES-1228/ME:4#
config ssh server
Purpose
Syntax
Description
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
password – This parameter may be chosen if the administrator wishes to use a locally
configured password for authentication on the Switch.
publickey − This parameter may be chosen if the administrator wishes to use a publickey
configuration set on a SSH server, for authentication.
hostbased − This parameter may be chosen if the administrator wishes to use a host
computer for authentication. This parameter is intended for Linux users requiring SSH
authentication techniques and the host computer is running the Linux operating system
with a SSH program previously installed.
[enable | disable] − This allows users to enable or disable SSH authentication on the
Switch.
Only Administrator-level users can issue this command.
Used to display the SSH authentication mode setting.
show ssh authmode
This command will allow users to display the current SSH authentication set on the Switch.
None.
None.
Used to configure the SSH server.
config ssh server {maxsession <int 1-8> | contimeout <sec 120-600> | authfail<int 2-
20> | rekey [ 10min | 30min | 60min | never] }(1)
This command allows users to configure the SSH server.
224