D-Link DES-1228 Reference Manual page 65

DES-1228/ME Metro Ethernet Switch Command Line Interface
Copyright(C) 2009 D-Link Corporation. All rights reserved.
DES-1228/ME:4#
DES-1228/ME:4#
DES-1228/ME:4#download cfg_fromTFTP 10.41.44.44 c:\cfg\setting.txt
Command: download cfg_fromTFTP 10.41.44.44 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
The very end of the autoconfig process appears like this:
Success.
DES-1228/ME:4#
DES-1228/ME:4## ROUTE
DES-1228/ME:4#
DES-1228/ME:4#
DES-1228/ME:4##---------------------------------------------------
DES-1228/ME:4##
DES-1228/ME:4##---------------------------------------------------
DES-1228/ME:4#
DES-1228/ME:4#
NOTE: With autoconfig enabled, the Switch ipif settings now define the Switch as a DHCP client. Use
the show switch command to display the new IP settings status.
disable autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Firmware: Build 1.00.B04
End of configuration file for DES-1228/ME
Use this to deactivate auto configuration from DHCP.
disable autoconfig
This instructs the Switch not to accept auto configuration instruction from the DHCP
server. This does not change the IP settings of the Switch. The ipif settings will continue
as DHCP client until changed with the config ipif command.
None.
Only Administrator-level users can issue this command.
60