Lldp Commands - D-Link DES-1228 Reference Manual

The LLDP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command
enable lldp
disable lldp
config lldp message_tx_interval
config lldp
message_tx_hold_multiplier
config lldp tx_delay
config lldp reinit_delay
config lldp notification_interval
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp ports
config lldp forward_message
show lldp
show lldp mgt_addr
show lldp ports
show lldp local_ports
show lldp remote_ports
show lldp statistics
show lldp statistics ports
Each command is listed, in detail, in the following sections.
enable lldp
Purpose
Syntax
Description
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
<sec 5 - 32768 >
< int 2 - 10 >
< sec 1 - 8192 >
< sec 1 - 10 >
<sec 5 - 3600 >
[<portlist>|all] notification [enable | disable]
[<portlist>|all] admin_status [tx_only | rx_only | tx_and_rx | disable]
[<portlist>|all] mgt_addr ipv4 <ipaddr> [enable | disable]
[<portlist>|all] basic_tlvs [all | {port_description | system_name |
system_description | system_capabilities}] [enable | disable]
[<portlist>|all] dot1_tlv_pvid [enable | disable]
[<portlist>|all] dot1_tlv_vlan_name [vlan [all | <vlan_name 32> ] | vlanid
<vidlist> ] [enable | disable]
[<portlist>|all] dot1_tlv_ protocol_identity[all | { eapol | lacp | gvrp | stp }]
[enable | disable]
config lldp ports [<portlist>|all] dot3_tlvs [all | {mac_phy_configuration_status |
link aggregation | power_via_mdi | maximum_frame_size}] [enable | disable]
[enable | disable]
{ipv4 <ipaddr>}
{<portlist>}
{ <portlist>} {mode [brief | normal | detailed]}
{<portlist>} {mode [brief | normal | detailed]}
{<portlist>}
Used to enable LLDP operations on the switch.
enable lldp
This is a global control for the LLDP function.
When this function is enabled, the switch can start to transmit LLDP packets and receive
251
38
LLDP C
OMMANDS