Scrub Disks - HP P2000 G3 Cli Reference Manual

scrub disks

Description Analyzes specified disks to find and fix disk errors. This command acts on available disks, global
spares, and dedicated spares, but not on leftover disks. This command will fix bad-block
replacement errors, medium errors, hard errors, and SMART-count errors for the specified disks.
You can use a disk while it is being scrubbed. To check the progress of a disk scrub (DRSC) job, use
the show disks
When a disk scrub operation starts, event 208 is logged. When a disk scrub operation ends, event
209 is logged and specifies whether errors were found and whether user action is required.
Syntax
scrub disks disks
Parameters disks
IDs of the disks to scrub. For vdisk syntax, see
Example Start scrubbing disks 1.1 and 1.3:
# scrub disks 1.1,1.3
Info: Start scrubbing the disk at location -
Info: Start scrubbing the disk at location -
Success: Command completed successfully. (2012-10-08 11:14:11)
See also • abort scrub
• scrub vdisk
• set advanced-settings
• set job-parameters
• show disks
command.
Command syntax on page 22.
(1.1)
(1.3)
HP P2000 G3 MSA System CLI Reference Guide 131