Show Job-Parameters - HP P2000 G3 Cli Reference Manual

show job-parameters

Description Shows parameters for background vdisk scrub, partner firmware upgrade, and other jobs.
Syntax
show job-parameters
Output Vdisk Background Scrub
Shows whether disks in vdisks are automatically checked for disk defects to ensure system health. The
interval between background vdisk scrub finishing and starting again is 24 hours.
• Disabled: Background vdisk scrub is disabled.
• Enabled: Background vdisk scrub is enabled. This is the default.
Partner Firmware Upgrade
Shows whether component firmware versions are monitored and will be automatically updated on
the partner controller.
• Disabled: Partner firmware upgrade is disabled.
• Enabled: Partner firmware upgrade is enabled. This is the default.
Utility Priority
Priority at which data-redundancy utilities, such as vdisk verify and reconstruct, run with respect to
I/O operations competing for the system's processors. (This does not affect vdisk background scrub,
which always runs at "background" priority.)
• High: Utilities have higher priority than host I/O. This can cause heavy I/O to be slower than
normal. This is the default.
• Medium: Utility performance is balanced with host I/O performance.
• Low: Utilities run at a slower rate with minimal effect on host I/O.
Example Show a system's job parameters:
# show job-parameters
Job Parameters
--------------
Vdisk Background Scrub: Disabled
Partner Firmware Upgrade: Enabled
Utility Priority: High
Success: Command completed successfully. (2012-01-18 15:07:25)
Basetypes • job-parameters
• status
See also • set job-parameters
248 Alphabetical list of commands