Show Iscsi-Parameters - HP P2000 G3 Cli Reference Manual

show iscsi-parameters

Description For iSCSI, shows system-wide iSCSI parameters.
Syntax
show iscsi-parameters
Output CHAP
Whether Challenge-Handshake Authentication Protocol is enabled or disabled.
Jumbo Frames
Whether jumbo-frame support is enabled or disabled.
iSNS
Whether Internet Storage Name Service support is enabled or disabled.
iSNS IP
Address of the iSNS server.
iSNS Alt IP
Address of the alternate iSNS server.
iSCSI Speed
Whether host port link speed is set to auto-negotiate (auto) or to 1 Gbit/sec.
iSCSI IP Version
Whether iSCSI host port addresses use IPv4 or IPv6 format.
Example Show system-wide iSCSI parameters:
# show iscsi-parameters
iSCSI Parameters
----------------
CHAP: Disabled
Jumbo Frames: Disabled
iSNS: Disabled
iSNS IP: 0.0.0.0
iSNS Alt IP: 0.0.0.0
iSCSI Speed: auto
iSCSI IP Version: 4
Success: Command completed successfully. (2012-01-18 15:05:53)
Basetypes • iscsi-parameters
• status
See also • set iscsi-parameters
HP P2000 G3 MSA System CLI Reference Guide 247