Show Snapshots - HP P2000 G3 Cli Reference Manual

show snapshots

Description Shows information about snapshots for a specified controller, master volume, or snap pool. If no
parameters are specified, information about all snapshots is shown.
Syntax
show snapshots
[controller a|b|both]
[master-volume volume]
[snap-pool volume]
[type standard|replication|all]
Parameters controller a|b|both
Optional. Shows snapshots owned by controller A only, by controller B only, or by either controller
(both). If this parameter is omitted, snapshots owned by either controller are shown.
master-volume volume
Optional. Shows snapshots associated with the specified master volume name or serial number. For
volume syntax, see
snap-pool volume
Optional. Shows snapshots associated with the specified snap pool name or serial number. For
volume syntax, see
type standard|replication|all
Optional. Shows only standard (non-replication) snapshots, only replication snapshots, or snapshots
of all types. If this parameter is omitted, snapshots of all types are shown.
Output Vdisk
Vdisk name.
Serial Number
Snapshot serial number.
Name
Snapshot name.
Creation Date/Time
Date and time the snapshot was prepared or committed.
Status
•
Available
• Unavailable: See the Status-Reason value.
Status-Reason
Shows N/A for Available status, or one of the following reasons for Unavailable status:
• MV Not Accessible: Master volume is not accessible.
• MV Not Found: Master volume is not found.
• SP Not Accessible: Snap pool is not accessible.
• SP Not Found: Snap pool is not found.
• SS Pending: Snapshot is pending.
• VC-MD In Progress: Volume-copy with modified data is in progress.
• RB-MD In Progress: Rollback with modified data is in progress.
Source Volume
Name of the volume that the snapshot was taken of.
Snap-pool Name
Snap pool name.
Snap Data
Total amount of preserved and write data associated with the snapshot.
286 Alphabetical list of commands
Command syntax on page 22.
Command syntax on page 22.