Show Network-Parameters - HP P2000 G3 Cli Reference Manual

show network-parameters

Description Shows the settings and health of each controller module's network port.
Syntax
show network-parameters
Output IP Address
Network port IP address.
Gateway
Network port gateway IP address.
Subnet Mask
Network port IP subnet mask.
MAC Address
Controller's unique Media Access Control address.
Addressing Mode
• Manual: Network settings set manually (statically).
DHCP: DHCP used to set network parameters.
•
Link Speed
• Unknown: Either the link speed has not been set, or it has been unset because the controller
module was removed from its enclosure.
• 10mbps: The network port link speed is set to 10 Mb/s.
• 100mbps: The network port link speed is set to 100 Mb/s.
Duplex Mode
• Undefined: Either the duplex mode has not been set, or it has been unset because the
controller module was removed from its enclosure.
• Half: The network port duplex mode is set to half duplex.
• Full: The network port duplex mode is set to full duplex.
Auto Negotiation
• Disabled: Either the network port has not been set, or it has been unset because the controller
module was removed from its enclosure, or the port is connected to a switch and is set to use the
link speed and duplex mode shown by the Link Speed and Duplex Mode fields.
• Enabled: The network port is set to auto-negotiate a link speed (up to the maximum speed
shown by the Link Speed field) and duplex mode with a connected Ethernet switch.
Health
The health of the network connection.
•
OK
•
Degraded
Health Reason
If Health is not OK, this field shows the reason for the health state.
Health Recommendation
If Health is not OK, this field shows recommended actions to take to resolve the health issue.
HP P2000 G3 MSA System CLI Reference Guide 253