Scrub Vdisk - HP P2000 G3 Cli Reference Manual

scrub vdisk

Description Analyzes specified vdisks to find and fix disk errors. This command acts on disks in a vdisk but not
dedicated spares or leftover disks. This command will fix parity mismatches for RAID 3, 5, 6, and
50; mirror mismatches for RAID 1 and 10; and media errors for all RAID levels.
Vdisk scrub can last over an hour, depending on vdisk size, utility priority, and amount of I/O
activity. However, a "foreground" scrub performed with this command is typically faster than a
background scrub enabled with the
being scrubbed. To check the progress of a vdisk scrub (VRSC) job, use the
When a vdisk scrub operation starts, event 206 is logged. When a vdisk scrub operation ends,
event 207 is logged and specifies whether errors were found and whether user action is required.
Syntax
scrub vdisk vdisks
Parameters vdisks
Names or serial numbers of the vdisks to scrub. For vdisk syntax, see
Example Start scrubbing vdisk vd1:
# scrub vdisk vd1
Info: Scrub was started on vdisk vd1. (vd1)
Success: Command completed successfully. (2012-01-20 15:41:38)
• abort scrub
See also
• scrub disks
• set advanced-settings
• set job-parameters
• show vdisks
132 Alphabetical list of commands
set job-parameters command. You can use a vdisk while it is
show vdisks command.
Command syntax on page 22.