HP P2000 G3 Cli Reference Manual page 157

Hide thumbs Also See for P2000 G3:

Table of Contents

On a system with FC ports, set the link speed to 4 Gbit/sec for ports A1 and B1; set controller A

ports to request loop ID 5 and controller B ports to request loop ID 32; and suppress the confirmation

# set host-parameters speed 4g ports a1,b1 fibre-loop-id 5,32 noprompt

Info: Changes to FC loop IDs will not take effect until the affected Storage

Controller is rebooted.

Success: Command completed successfully. - The host parameters were changed

successfully. (2012-01-21 15:46:14)

On a system with iSCSI ports, for port A3 change the IP address:

# set host-parameters ip 10.134.50.6 port a3 iscsi-ip-version ipv4

WARNING: This change will take effect immediately. Changes may affect access to

data. Are you sure? yes

Success: Command completed successfully. - The host parameters were changed

successfully. (2012-01-21 15:46:51)

Specify that iSCSI ports will use IPv6 addressing:

# set host-parameters iscsi-ip-version ipv6

Success: Command completed successfully. - iSCSI parameter(s) were changed

successfully. (2012-01-21 15:47:30)

Table of Contents