HP P2000 G3 Cli Reference Manual page 229

from-event
Optional. Shows events including and after the specified event ID. If this number is smaller than the
ID of the oldest event, events are shown from the oldest available event. Events are shown only for the
controller that the event ID specifies (A or B). This parameter can be used with the to parameter or
the to-event parameter.
to-event
Optional. Shows events before and including the specified event ID. If this number is larger than the
ID of the oldest event, events are shown up to the latest event. Events are shown only for the controller
that the event ID specifies (A or B). This parameter can be used with the from parameter or the
from-event parameter.
a|b|both|error
Optional. Specifies to filter the event listing:
• a: Shows events from controller A only. Do not use this parameter with the from-event
parameter or the to-event parameter.
• b: Shows events from controller B only. Do not use this parameter with the from-event
parameter or the to-event parameter.
both: Shows events from both controllers. Do not use this parameter with the from-event
•
parameter or the to-event parameter.
• error: Shows Warning, Error, and Critical events.
Date and time when the event was logged.
Output •
• Event code identifying the type of event to help diagnose problems; for example, [181]
• Event ID prefixed by A or B, indicating which controller logged the event; for example, #A123
• Model, serial number, and ID of the controller module that logged the event.
• Severity:
• CRITICAL: A failure occurred that may cause a controller to shut down. Correct the problem
immediately.
• ERROR: A failure occurred that may affect data integrity or system stability. Correct the
problem as soon as possible.
• WARNING: A problem occurred that may affect system stability but not data integrity. Evaluate
the problem and correct it if necessary.
• INFORMATIONAL: A configuration or state change occurred, or a problem occurred that the
system corrected. No action is required.
• Event-specific message giving details about the event.
Example Show the last two events:
# show events last 2
Show the last three non-Informational events:
# show events last 3 error
Show all events from April 30 201 1 at 1 1:59:00 p.m. through May 2 201 1 at 1 1:59:00 a.m.:
# show events from 043011235900 to 050211115900
Show a range of events logged by controller A:
# show events from-event a100 to-event a123
Show detailed output for a specific event:
# show events from-event A2264 to-event A2264 detail
Basetypes • events
• status
ID
event-
ID
event-
HP P2000 G3 MSA System CLI Reference Guide 229