HP P2000 G3 Cli Reference Manual page 54

noprompt
Optional in console format; required for XML API format. Suppresses the prompt to revert the
transaction if the command fails, which requires a yes or no response. If this parameter is specified
and the command fails, the transaction is automatically reverted.
nowait
Optional. Adding a volume to a replication set can take the Storage Controller several minutes to
complete. This parameter allows that processing to continue in the background so the Management
Controller can process other commands.
primary-address ip=address|iqn=IQN|wwn=WWN
Optional. Specifies host ports on the local system by IP address, World Wide Node Name, or World
Wide Port Name. An IP address value can include a port number; for example, 10.134.2.1:3260.
Multiple values must be separated by commas and no spaces; for example:
ip=10.134.2.1,10.134.2.2.
priority low|medium|high
Optional. Priority of the replication process on the replication volumes: low, medium, or high.
remote-system system
Optional; required if the remote-vdisk or remote-volume parameter specifies a destination in
a remote system. Name or network-port IP address of the remote system.
remote-vdisk vdisk
Optional. Name or serial number of the vdisk that the remote volume and snap pool should be
created in. If the vdisk is on a remote system:
• You must specify the remote-system parameter.
• If the local and remote MCs can communicate, you can specify a name or serial number;
otherwise, you must specify a serial number.
The snap pool created on the secondary system will be the same size as the snap pool on the
primary system.
remote-volume volume
Optional; do not use with the remote-vdisk parameter. Name or serial number of a
replication-prepared volume to use as a secondary volume. If the volume is on a remote system and
the local and remote MCs can communicate, you can specify a name or serial number; otherwise,
you must specify a serial number.
reserve size[B|KB|MB|GB|TB|KiB|MiB|GiB|TiB]
Optional. Specifies the size of the snap pool to create if the primary volume is a standard volume.
The size value uses the current base, as shown by the
can be specified as follows.
• If base 2 is in use: B (bytes), KiB (kibibytes), MiB (mebibytes), or GiB (gibibytes).
• If base 10 is in use: B (bytes), KB (kilobytes), MB (megabytes), or GB (gigabytes).
If no unit is specified, the unit is 512-byte blocks. If this parameter is omitted, the size will be either
20% of the volume size or 5.37 GB, whichever is larger.
NOTE:
This can result in all snapshots being deleted due to the snap pool running out of space. Create snap
pools of at least 50 GB to avoid this situation.
secondary-address ip=IPs|wwnn=WWNNs|wwpn=WWPNs
Optional if the MCs can communicate and the remote-system parameter is specified; required if
the MC cannot communicate and a replication-prepared volume is specified. Specifies host ports on
the remote system by IP address, World Wide Node Name, or World Wide Port Name. An IP
address value can include a port number; for example, 10.134.2.1:3260. Multiple values must be
separated by commas and no spaces; for example: ip=10.134.2.1,10.134.2.2.
54 Alphabetical list of commands
In rare cases, a large amount of I/O can cause a snap pool that is too small to fill quickly.
show cli-parameters
command. The unit