Installing An I/O Module; Pcie Module - Dell PowerEdge FX2 Owner's Manual

Figure 39. Removing and installing an I/O module
1. I/O module
3. release latch
Next steps
Install the I/O module.
Related Tasks

Installing an I/O module

Installing an I/O module
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
Steps
1. Unpack the I/O module and prepare it for installation.
For instructions, see the documentation that is shipped with the I/O module.
2. Slide the I/O module into the enclosure until it engages with the connector on the midplane and the
release latch snaps into place.
3. Connect all cables that must be attached to the I/O module.
See the I/O module documentation for information about its cable connections.

PCIe module

PowerEdge FX2s supports eight PCIe modules. Each PCIe module has an expansion card slot in which a
low profile expansion card can be installed.
NOTE: PowerEdge FX2 does not support PCIe modules.
Safety instructions.
2. I/O module handle
49