Dell PowerEdge FX2 Owner's Manual page 76

8. Remove the screws that secure the KVM cover.
9. Remove the screws that secure the cable tube on the right side of the chassis.
10. Place the cable tube on the chassis without removing the KVM panel cable and the KVM panel.
11. Lift the midplane assembly from the system and place it on top of the chassis.
NOTE: Exercise care when removing midplane assembly and placing it on the chassis, to
prevent any damage to the KVM and control panel cables.
Figure 59. Removing and installing the cable tubes
1. screw on the KVM cover
3. Hex screw on the KVM panel (2)
5. cable tube on the left side of the chassis
7. tabs on the cable tubes
9. KVM panel cable
12. Push the KVM cable latch vertically up to disconnect the cable from the connector on the midplane.
13. Disconnect the control panel cable connector from the connector on the midplane.
76
2. KVM panel cover
4. KVM panel board
6. screws on the cable tubes (6)
8. control panel cable
10. cable tube on the right side of the
chassis