Steps
1.
Lift the Mylar insulator from the midplane.
2.
Remove the two fan cables connected to the midplane.
3.
Remove the two screws that secure the fan cable clips to the system.
Figure 57. Removing and installing midplane assembly components
1.
midplane
3.
screw (2)
4.
Remove the five screws that secure the midplane assembly to the system.
Figure 58. Removing and installing the midplane
1.
KVM cable
3.
control panel cable
5.
cable cover
7.
power interposer board
5.
Remove the screws that secure the cable tube on the left side of the chassis.
6.
Remove the control panel cable from the cable tube.
7.
Remove the screws on the front of the KVM panel that secure the KVM panel board.
2.
fan-cable clip (2)
4.
Mylar insulator
2.
midplane
4.
midplane assembly screw (5)
6.
power bus bar
75