Installing The Kvm Panel - Dell PowerEdge FX2 Owner's Manual

3. connector
5. KVM panel cover
Next steps
Install the KVM panel.
Related Tasks

Installing the KVM panel

Installing the KVM panel
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: This is a field replaceable unit (FRU). Removal and installation procedures must be performed
only by Dell certified service technicians.
1. Ensure that you read the
2. Follow the procedure listed in
3. Remove the KVM panel.
NOTE: You must remove the KVM panel to replace a faulty panel.
Steps
1. Connect the KVM panel cable to the KVM panel.
2. Press the connector latch into place.
3. Install the screw to secure the KVM panel cover to the KVM panel.
4. Align the screw holes on the KVM panel with the screw holes on the side of the system.
5. Install the two screws to secure the KVM panel to the side of the system.
6. Insert the KVM panel cable in the cable tube.
7. Align the screw holes on the cable tube with the screw holes on the side of the system.
8. Install the three screws to secure the cable tube to the side of the system.
Next steps
Follow the procedure listed in
Safety instructions.
Before working inside your
After working inside your
4. KVM panel
system.
system.
85