Table of Contents
Advertisement
Chapter 3 Setup
1.
Turning on the Server
Pressing POWER Switch at the front of the server turns on the server.
Turn on the server by using the following procedure.
1. Turn on the peripheral devices and display unit.
2. Remove Front Bezel.
3. If STATUS LED1, 2 are lighting green or amber, wait until it goes off.
4. Press POWER Switch at the front of the server.
POWER LED is turned on green and after a while, logo appears on the display.
16x 2.5-inch Drive Model
POWER switch
26x 2.5-inch Drive Model / 3.5-inch Drive Model
While logo is being displayed, the self-diagnostic program (POST) runs and diagnoses the hardware. For
details, see Chapter 3 (1.1 POST).
154
Wait for at least 30 seconds before turning on the server after turning it off.
Tips
Note
If the power cord is connected to power control system such as an Uninterruptible
Power Supply (UPS), make sure that the power control system is turned on.
Do not connect or disconnect USB device while POST is running.
Important
POWER switch
Express5800/R120g-2E User's Guide
1. Turning on the Server
Advertisement
Table of Contents
