Removal - NEC Exress5800 Series User Manual

Chapter 2 Preparations
7. Connect an interface cable and power cable.
Power cable
8. Continue to install or remove internal optional devices, mount and connect the server, and power on the
server.
9. Make sure that no error messages are displayed on POST screen.
For details on POST error messages, see Chapter 3 (1. POST Error Message) in "Maintenance Guide".
10. Install the driver for backup device as needed.
1.14.2

Removal

Remove the backup device in reverse order of installation steps.
Note Use the power cable that extends to the expansion bay of the server.
If it is too short to connect, use the extension cable that comes with the backup device.
Use K410-353(00) Internal USB Cable for the USB cable.
If the USB cable comes in contact with the cooling fan unit, fix the cable using the cable
clamp on the expansion bay side.
Important When N8151-125 Internal RDX (USB) is connected, the boot device priority may be
changed. On the Boot menu of BIOS Setup Utility, specify the boot priority of
removable device lower than that of boot device.
Express5800/R120g-2E User's Guide
1. Installing Internal Optional Devices
USB cable
87