Table of Contents
Advertisement
Chapter 1 General Description
4.3
Rear View
(1)
(2)
(8)-1
(1) Power Unit
A power supply for supplying the DC power to the server.
(2) AC Inlet
A socket for connecting the power cord.
(3) AC POWER LED
An LED for showing the power supply status.
(See page 38)
(4) Cap Screw
A screw for fixing the top cover.
(5) Slot for PCI Card
Slots for installing PCI cards.
"1", "2", "3", "4", and "5" indicate PCI slot number.
(6) USB Connectors
Connectors for connecting USB interface devices.
(7) LINK/ACT LED
LEDs for showing the access status of LAN.
(See page 37)
(8) LAN Connectors
LAN connectors which supports
1000BASE-T/100BASE-TX/10BASE-T.
(10)-1: LAN1 port connector
(10)-2: LAN2 port connector
If Shared BMC LAN feature is enabled in ROM Utility, LAN
connector 1 can also be used as the management LAN port.
Sharing port is not recommended from the point of performance
and security.
28
(3)
(11)
(12) (13)
(7)
(10)
(9)
Express5800/R120g-2E User's Guide
(5)-1 (5)-2 (5)-3 (5)-4 (5)-5
(4)
(9)
(8)-2
(7)
(6)
(9) SPEED LED
LEDs for showing the transfer speed of LAN ports.
(See page 37)
(10) Management LAN Connector
A LAN connector which supports
1000BASE-T/100BASE-TX/10BASE-T. This port
cannot be used as a data transmission port.
This port is used for connecting to EXPRESSSCOPE
Engine 3.
(11) Serial Port A (COM) Connector
A connector for connecting serial interface devices.
This cannot connect to a network line directly.
(12) Display Connector
A connector for connecting a display.
This connector cannot be used with the display
connector on front panel at the same time.
(13) UID Switch/LED
A switch for turning on/off UID LED.
Pressing the switch once turns on UID LED and
pressing again turns off the LED.
Commands from the software also cause it to turn on
or flash.
(See page 35)
(14) 2.5-inch Additional HDD Cage Bay
A bay for installing 2.5-inch Additional HDD cage
(Rear). Not available in 16x 2.5-inch drive models.
4. Names and Functions of Parts
(14)
Advertisement
Table of Contents
