NEC Exress5800 Series User Manual page 168

Chapter 3 Setup
4. On Off-line TOOL MENU, select Server Configuration Utility → EXPRESSSCOPE Engine 3 →
Configuration → Network → IPv4 Property or IPv6 Property.
5. On the following screen, select Enable when you use DHCP, or select Disable and specify IP Address
(Required), Subnet Mask (Required), Default Gateway, and DNS Server when you do not use DHCP.
6. Connect the LAN cable to the management LAN connector in order to connect to the network. It will be
available for use if you access EXPRESSSCOPE Engine 3 via Web browser from management PC
according to the setting.
168
If Shared BMC LAN is enabled, Web feature, remote media/KVM feature, or command
Tips
line interface feature may be interrupted. In this case, wait for a while, and connect with
network again.
When IPv4 Property is selected
Express5800/R120g-2E User's Guide
3. EXPRESSSCOPE Engine 3